#1 Fridge Repair Service Provider In Kolkata

Inverter Fridge Repair Service in Kolkata @ 299/-

Inverter fridges are brilliant when they work — quiet, efficient, gentle on the electricity bill. The catch is that they’re run by a sensitive electronic board, and Kolkata’s voltage swings are exactly what that board hates. When an inverter fridge plays up, the fault is usually electrical, not mechanical — and that needs a technician who actually understands the board. We do, the visit is a flat ₹299, and we’ll get to you the same day.

Built for inverter fridges

The compressor that never fully stops

An ordinary fridge compressor is either on or off. An inverter compressor instead varies its speed — running slow most of the time and speeding up only when needed. That's why these fridges are quieter and cheaper to run. A small inverter board (PCB) controls all of it, reading sensors and adjusting the motor constantly.

That board is also the weak point. In a city where the voltage dips during load and spikes when it returns, the electronics take a beating. We see plenty of inverter fridges where the compressor is perfectly healthy but a surge has killed the board or a sensor — and a technician who only checks the compressor will misread the whole thing.

So we test the supply, the inverter board and the sensors as a system. When the board has genuinely failed we replace it; when it's a cheaper sensor or a wiring fault, you pay for that instead. Many side-by-side fridges are inverter-driven too, and the full lineup is on our fridge repair in Kolkata page.

Inverter — quick facts

What it isVariable-speed compressor + PCB
UpsideQuieter, energy-efficient
Weak pointBoard / sensors vs voltage swings
Top faultsInverter PCB, sensor, surge damage
Visit chargeFlat ₹299, adjusted in repair

What we see most

Inverter fridge faults we fix every week

Inverter problems are mostly electronic. We diagnose the board and supply before quoting — never a blind board swap.

Inverter board failure

The PCB that drives the compressor stops working — the fridge may be silent, blinking, or simply not cooling at all.

Voltage / surge damage

A spike when power returns can fry the board or a sensor while the compressor stays fine. We repair the damage and advise prevention.

Sensor / thermistor errors

A faulty sensor feeds wrong temperatures to the board, so the fridge over-cools, under-cools, or cycles oddly.

Weak or inconsistent cooling

If the compressor can't ramp up properly, cooling becomes patchy. We check whether it's the drive, the gas, or the board.

Clicking or restarting

An inverter that keeps trying to start and clicking off often has a board or compressor-drive fault we can pinpoint.

Gas leak with good electronics

Sometimes the board is fine and it's simply low refrigerant. We confirm, find the leak, seal and refill.

From inverter fridge owners

What customers nearby say

★★★★★

"After a power cut my inverter fridge just stopped cooling. The technician checked the board, found surge damage to one part, and repaired it — didn't replace the whole PCB like another shop quoted. Also suggested a stabiliser. Sound advice."

T
Tanmoy Ghosh
Madhyamgram
★★★★★

"My fridge kept clicking and restarting. He explained it was the inverter drive, showed me the reading, and fixed it the same day. Knew exactly what he was looking at — clearly does these often."

M
Madhumita Sen
Birati

Inverter — your questions

Frequently asked

What makes an inverter fridge different to repair?

An inverter fridge uses a variable-speed compressor run by an electronic inverter board, instead of switching fully on and off. It's quieter and saves power, but the board and sensors are delicate, so faults tend to be electrical rather than mechanical. We diagnose the board, sensors and supply — not just the compressor.

It stopped cooling after a voltage fluctuation. Fixable?

Yes — voltage spikes are the number-one cause of inverter failure in Kolkata. A surge can damage the inverter PCB or a sensor while leaving the compressor fine. We test the board and sensors, repair or replace the damaged part, and suggest a suitable stabiliser so it doesn't recur.

How much does inverter fridge repair cost in Kolkata?

The visit and diagnosis is a flat ₹299, adjusted into your bill. An inverter board or sensor costs more than a basic thermostat, so you get the exact repair price upfront after diagnosis, before any work begins.

Do I need a stabiliser for my inverter fridge?

Most modern inverter fridges have a wide built-in voltage range, but in parts of Kolkata with frequent surges or low voltage, a good stabiliser is cheap insurance for an expensive board. We'll advise based on the supply at your home.

Do you repair all inverter brands?

Yes — Samsung, LG, Whirlpool, Godrej, Haier, Bosch and Panasonic inverter models, across Kolkata, same-day from our Birati base.

Same-day · ₹299 · board specialists

Inverter fridge acting up? Get it read properly

Don't pay for a full board swap you may not need. We diagnose the inverter board, sensors and supply, then fix the real fault under a 30-day warranty.